Online Violin Tuner

Tune a violin with a free online violin tuner that listens through the microphone in your phone, tablet or laptop. Bow or pluck a string and it names which of the four you played, G, D, A or E, shows how many cents flat or sharp it is and says which way to go. The A can be set anywhere from 415 to 466 Hz, for an orchestra at 442 or a baroque instrument at 415, and viola, cello and mandolin tunings are in the same list.

Before you start: play one open string at a time with a slow, even bow, or pluck it. Pressing hard with the bow raises the pitch a little, so use the weight you play with.

Press Start and allow the microphone when your browser asks.

Tune your instrument

Hz

–

– cents

Start the tuner, then play a note

You played
–
Target
–

Reference tones

Each button plays its note for four seconds, rich in harmonics so a phone speaker that cannot reach a bass string's fundamental still sounds its pitch. The tuner pauses while it plays; press it again or Esc to stop.

You should see
The note you played, its octave and how many cents it is off, a moment after you pluck. With an instrument chosen, the string you played lights up and the line under the strip says which way to turn: flat means tune up, sharp means tune down. Within 3 cents either side the reading turns green and says In tune.
If it looks wrong
  • Nothing shows: check the microphone in the list, its level in your system's sound settings, and play louder or closer. Talking, noise and two strings at once show nothing on purpose.
  • The reading jumps: mute the other strings with your hand, and read after the first instant of the note, which is a little sharp on a hard pluck.
  • It names the wrong string: a string tuned far off its note can sit nearer the next one. Choose Chromatic, bring it close by note name, then switch back.

How to tune a violin

Know the four notes
A violin is tuned G, D, A, E from the thickest string to the thinnest, each a fifth above the last. The A is the A above middle C, the note an orchestra tunes to.
Start with the A
Tune the A string first and the others to it, as players do. Press Start tuner, play the open A with a long bow stroke and watch the reading settle.
Small changes with the fine tuners
If the string is within about half a semitone, turn the fine tuner at the tailpiece: clockwise raises the pitch. Fine tuners move the note a little at a time and are the safe way to finish.
Larger changes with the pegs
For a string far from its note, use the peg, turning a little while pushing it gently into the pegbox so it holds. Tune from below the note up to it: a string wound too tight can break, and the E string most easily.
Check the fifths
When all four read in tune, play two neighboring strings together. A clean, steady fifth with no slow wobble means the pair agrees.

How the tuner finds a note, what cents are and how to read the strip are explained on the main online tuner page, which also has a chromatic setting for any instrument. Other instruments: guitar tuner, bass tuner and ukulele tuner.

Violin, viola, cello and mandolin tunings

Each instrument from its lowest string to its highest, with every string's equal-tempered frequency at A4 = 440 Hz. A mandolin has the violin's four notes, each on a pair of strings.

TuningString 5String 4String 3String 2String 1
ViolinG3
196.00 Hz
D4
293.66 Hz
A4
440.00 Hz
E5
659.26 Hz
ViolaC3
130.81 Hz
G3
196.00 Hz
D4
293.66 Hz
A4
440.00 Hz
CelloC2
65.41 Hz
G2
98.00 Hz
D3
146.83 Hz
A3
220.00 Hz
MandolinG3
196.00 Hz
D4
293.66 Hz
A4
440.00 Hz
E5
659.26 Hz

Where the notes and frequencies come from

Violin tuner FAQ

  1. What notes are violin strings tuned to?

    The four strings are G, D, A and E from the lowest to the highest, a fifth apart. With A4 at 440 Hz they sound at 196.00, 293.66, 440.00 and 659.26 Hz.

  2. Should I tune with the pegs or the fine tuners?

    Use the fine tuners for small corrections and the pegs for large ones. A fine tuner changes the pitch slowly and cannot slip, so it is the easier and safer of the two when the string is nearly right. If a fine tuner is screwed all the way in, loosen it most of the way, bring the string close with the peg and finish with the fine tuner.

  3. Can I tune to A = 442 or A = 415?

    Yes. Set the A4 reference to any value from 415 to 466 Hz and every string, reading and reference tone moves with it. Many orchestras tune to 442 or 443 Hz, and 415 Hz is the usual pitch for baroque instruments. The page remembers the setting in your browser.

  4. Does it tune a viola or a cello?

    Yes. Choose Viola or Cello in the Instrument list. A viola is tuned C, G, D, A, a fifth below a violin, and a cello has the same four notes one octave lower. The tunings table on this page gives the frequency of every string.

  5. Why does the reading move while I bow?

    Bow pressure and speed change the pitch of a string by a few cents, and the start of a stroke is less steady than its middle. Play a long, even stroke at a moderate volume and read the tuner once the needle settles. Plucking the string gives a quick check, with a note that starts slightly sharp and falls.